Anti-Shatter Safety Window Film Class B - 100microns

Code: FILM007
Anti-Shatter Safety Window Film Class B - 100micronsAnti-Shatter Safety Window Film Class B - 100microns
< >
Anti-Shatter Safety Window Film Class B - 100micronsAnti-Shatter Safety Window Film Class B - 100microns
Discounts for quantity
x1-5 £9.99
x6 £8.99
Save £6.00
x11+ £5.99
Save £44.00

Anti-Shatter window film holds dangerous shards in place when the glass shatters. This 100micron film upgrades your glass to BS6206 Class B (see our section on relevant regulations below). To upgrade to Class A use FILM007b. Note that Class B is usually adequate for institutional buildings, workplaces, child nurseries and creches. It is also suitable for residential applications


    100 micron safety film
  • BS 6206 (6 and 4mm glass): B
  • BS EN 12600 (6 and 4mm glass): 2B
    175 micron safety film
  • BS 6206 (6 and 4mm glass): A
  • BS EN 12600 (6 and 4mm glass): 1B

Fit on internal face of windows in offices, commercial buildings, playgroups, crèches and private residences.

Manufactured using an advanced ultra-transparent polyester just a few microns thick, with an anti-abrasive (anti-scratch) coating and resistance to discolouration.

10 year warranty against peeling, cracking and demetallization of the film.

Please note: This is only available in increments of 1m

Performance stats

  • Allows 85% of visible light through
  • Reduces the sun's heat by 19%
  • Reduces damaging UV light by 95%

Optional Extras Selected items will be included with your purchase
Glass compatibility

Clear single glazed YES
Tinted single glazed YES
Clear double glazed YES
Tinted double glazed YES
Low-E double glazed YES
Clear laminated single glazed YES
Clear laminated double glazed YES

Relevant regulations

It is a legal requirement to have all relevant existing glazing made impact-safe and be so marked.

In addition the Building Regulations BS 6262 Part 4, Safety, Human Impact states that:

  • Every window or glazed area in a wall, partition, door, or gate shall be of safety material or be protected against breakage -ie, it should not break on impact or should break safely.
  • Safety glazing material must meet BS 6206 Class B in doors and side panels over 900mm wide, and Class C in those less than 900mm wide. Low level glazing must meet a minimum of BS 6206 Class C.
  • This entails the use of laminated, toughened or safety-wired glass, or plastic glazing sheet that meet BS 6206, or glass with plastic film applied so that the pane of glass with the film meets BS 6206 Class A or B.
  • Existing glazing must also be appropriately marked or featured so as to make it apparent and thus avoid the risk of collision because it is not properly visible.
  • In particular, large uninterrupted areas of glazing where people might reasonably think they can walk straight through.

Which glazing is affected?

'Critical locations' is the term given to describe of internal and external walls, doors and partitioning which are of primary concern in terms of glazing safety. These areas are depicted here and described in the two categories below:

Critical locations are:

Between the finished floor level and 1500mm (shoulder height) above that level in doors, and in side panels which fall within 300mm of either edge of the door.

Between the finished floor level and 800mm (waist height) above that level in the case of walls, partitions and windows.

It is important to note that any part of a glass pane affected must meet the requirements in its entirety and not just in the relevant section.

Film007 Class B
Looking out from inside
Film007 Class B
Looking in from outside
Customer Reviews
Rating: 4/5

"Fixing instructions online for glass safety film were very good"

Reviewed Friday, 28 October 2016

Rating: 4/5

"I have no previous experience of this product so can not compare it with other manufacturers/suppliers"

Reviewed Tuesday, 20 January 2015

Rating: 5/5

"just the right thing we required first class"

Reviewed Tuesday, 30 December 2014

Rating: 4/5

"looks quality"

Reviewed Sunday, 17 August 2014

Rating: 4/5

"Was a little difficult to put up on some inside doors with glass but after a couple of attempts did manage to get a good result."

Reviewed Tuesday, 25 February 2014

Rating: 2/5

"Product had bubbles with some dirt which can clearly spotted . It was brought to my attention after being installed.."

Reviewed Monday, 25 November 2013

Answer from Primrose: "Thanks for your review. All of our film should be sent out brand new and clean – however dirt and bubbles can become trapped in the film during the installation process. It is important to make sure that your windows are completely clean before installing the film as this can lead to dirt being trapped between the film and window. To avoid bubbles forming, the film must be installed slowly and a squeegee should be used to make it completely flat. "
Rating: 5/5

"good product, easy to apply after working out how to do it, found video a little confusing."

Reviewed Saturday, 27 July 2013

Rating: 5/5

"Just what I needed as we have a 9-mth old staying and I'm not sure if the glass on our internal doors are shatter-proof. However it is quite rigid and not that easy to bend so as my glass panes are only just larger than A4 I had to cut the film to fit before applying it rather than following the instructions to the letter."

Reviewed Monday, 8 July 2013

Rating: 5/5

"Relatively easy to apply, and ensures protection if glass becomes damaged."

Reviewed Sunday, 19 May 2013

Rating: 5/5

"Easy to cut and fit! Thanks"

Reviewed Monday, 22 April 2013

View more

Other people looked at

1 to 6 (of 6 products)    View all    1